[May-2023] The Best CIP Level 2 NACE-CIP2-001 Professional Exam Questions
Try 100% Updated NACE-CIP2-001 Exam Questions [2023]
NEW QUESTION # 53
In which type of concrete are laitance commonly encountered?
- A. Poured (wet cast)
- B. Concrete block (poured with a form)
- C. Glass fiber cement
- D. Gunite
Answer: A
NEW QUESTION # 54
When performing testing in accordance with ASTM D 2583 the inspector may observe:
- A. Cold flow or creep
- B. Cohesion failure
- C. Glue failure
- D. Adhesion failure
Answer: A
NEW QUESTION # 55
Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?
- A. Gathering
- B. Distribution
- C. Midstream
- D. Transmission
Answer: B
NEW QUESTION # 56
When environmental enclosures are being used an inspector needs to be concerned about:
- A. Lighting
- B. Structural integrity
- C. a), b), and c)
- D. Air changes
Answer: C
NEW QUESTION # 57
The cost of qualified Coating Inspection is normally offset by:
- A. Lower Coating Life Cycle Costs
- B. Lower Safety Enforcement Costs
- C. Lower Supervision Costs
- D. Lower Application Costs
Answer: A
NEW QUESTION # 58
The most likely area of failure on a buried external pipeline coating is the:
- A. Areas exposed to Ultra Violet light
- B. Ground bed
- C. Field joint coating
- D. Mainline coating
Answer: C
NEW QUESTION # 59
Inspector reports should always be copied to:
- A. The Contractor and Owner
- B. The Owner only
- C. All parties involved in the project
- D. Whomever the Owner identifies
Answer: D
NEW QUESTION # 60
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?
- A. Wetting stage
- B. Flow stage
- C. Gel stage
- D. Cure stage
Answer: B
NEW QUESTION # 61
You should bulk store coatings containing isocyanates
- A. in a heated warehouse.
- B. in a well ventilated area separate from the work place.
- C. wherever it is convenient
- D. in a refrigerated warehouses
Answer: B
NEW QUESTION # 62
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:
- A. Different than air blast cleaning
- B. The same as air blast cleaning
- C. Slightly different to air blast cleaning
- D. Comparable to air blast cleaning
Answer: B
NEW QUESTION # 63
A single component water borne acrylic coating cures by:
- A. Solvent Evaporation
- B. Co-Reaction
- C. Oxidation
- D. Coalescence
Answer: D
NEW QUESTION # 64
An Inspection and Test Plan is required when:
- A. When the Coating Applicator requests one
- B. When the Inspector requests one
- C. It is always required
- D. When the Owner specifies one
Answer: C
NEW QUESTION # 65
NACE Standards include:
- A. a) & b)
- B. Standard Practices
- C. a) only
- D. Material Requirements
Answer: A
NEW QUESTION # 66
Coating Surveys are legally required:
- A. On food and beverage vessels and can linings
- B. On commercial marine vessels and offshore platforms
- C. On high pressure gas lines and fireproofed structures
- D. On water tanks and potable water pipelines
Answer: B
NEW QUESTION # 67
When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:
- A. Ultra Sonic DFT Gauge
- B. Magnetic Gauge
- C. Eddy Current Gauge
- D. Tooke Gauge
Answer: D
NEW QUESTION # 68
Cold-applied tape
- A. have a cross-linked polyethylene backing and a heat-activated adhesive.
- B. are identifiable by its distinct colors, usually light blue, green, Or Grey.
- C. is polyethylene film, heat laminated, 'With an adhesive layer of butyl glue.
- D. is typically green or led and looks like "painted" finish.
Answer: C
NEW QUESTION # 69
You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor's supervisor. Upon arriving onsite the Contractor's supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:
- A. Challenge the supervisor's authority
- B. Express a willingness to work with the site team and follow the specification
- C. Suggest to the Owner that the supervisor should be removed from site
- D. Defend the previous inspector
Answer: B
NEW QUESTION # 70
Surface preparation of concrete is performed using:
- A. Methods that have been modified for concrete
- B. Methods that are the same as wood
- C. Methods that are exactly the same as steel
- D. Methods that are completely different to steel
Answer: A
NEW QUESTION # 71
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.
- A. False
- B. True
Answer: A
NEW QUESTION # 72
NACE Level 2 Inspectors have been authorized to perform:
- A. All types of inspection without supervision
- B. Visual inspection and Non-destructive testing
- C. Visual inspection, Non-Destructive and Destructive testing
- D. Visual inspection only
Answer: C
NEW QUESTION # 73
Examples of non-ferrous metals include
Select All that Apply:
- A. iron
- B. mild steel.
- C. copper
- D. aluminum
Answer: C,D
NEW QUESTION # 74
WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)
- A. True
- B. False
Answer: A
NEW QUESTION # 75
You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:
- A. Advise the other inspector he is using an incorrect method
- B. Review the specification with the other inspector to see what method was specified
- C. Advise your QC Manager to change the ITP to the use of the salt smart meter
- D. Redo the pre-cleaning based on the other inspectors results
Answer: B
NEW QUESTION # 76
......
NACE-CIP2-001 Exam Questions Get Updated [2023] with Correct Answers: https://www.testvalid.com/NACE-CIP2-001-exam-collection.html
Pass NACE-CIP2-001 Exam - Real Questions and Answers: https://drive.google.com/open?id=1_VhWwvLBIaMSogjm0qlkBWRpqqspwj0A