H35-912 Exam Questions Get Updated [2022] with Correct Answers
Practice H35-912 Questions With Certification guide Q&A from Training Expert TestValid
NEW QUESTION 23
In the process of replacing the signal cable and the power cable, the cable connection can be directly implemented according to the cable label. It is not necessary to perform the line sequence check according to the cable route.
- A. False
- B. True
Answer: A
NEW QUESTION 24
Regarding the seat belt on the car, which one is the correct statement?
- A. When you drive or ride, please fasten your seat belt
- B. When driving slowly, you don't have to wear a seat belt.
- C. When you drive, be sure to fasten your seat belt. You don't have to take a ride.
Answer: A
NEW QUESTION 25
Under the engineering service system, which of the following are the responsible persons for safety construction of the project? (Multiple choice)
- A. Project supervision
- B. Engineering supervision
- C. Customer Project Leader
- D. Project Manager
Answer: A,D
NEW QUESTION 26
Which is the most important purpose of wearing safety shoes when climbing a tower?
- A. Anti-foot
- B. Sun protection
- C. Non-slip
- D. Flood prevention
Answer: C
NEW QUESTION 27
Which are the correct statements in the SOP interpretation of the MA5800? (Multiple choice)
- A. The transmission equipment in engine room does not need to be installed.
- B. The DC power supply system of the engine room must have been installed to provide a stable power supply.
- C. The installation scenario must be clear: cement floor installation or anti-static floor installation, etc.
- D. Workers need to wear safety helmets and anti-shoes when entering the station.
Answer: B,C,D
NEW QUESTION 28
The following are the operations that should be described before the power-on of the communication device. What are the correct descriptions? (Multiple Choice)
- A. All power switches of the powered device are disconnected
- B. Check the electrical connection is firm and reliable
- C. The output switch of the power supply device is disconnected and the output voltage is normal.
- D. Measuring no short circuit inside the powered device
- E. Measure the power supply circuit without short circuit between each other and the ground
- F. Rated output current meets the needs of powered devices
Answer: A,B,C,D,E,F
NEW QUESTION 29
Which of the following statements about the up-and-down about PON technology is correct?
- A. PON technology data downlink uses broadcast
- B. PON technology data uplink uses broadcast
- C. PON technology downlink adopted wavelength is 1310nm.
- D. PON technology uplink adopted wavelength is 1490nm
Answer: A
NEW QUESTION 30
Which statement is correct about the working principle of the FTTx key technology PON?
- A. PON is the abbreviation of Passive Optical Network.
- B. SFU is a device directly connected to the upper layer network in the PON upper layer network.
- C. The ONU completes the PON service forwarding and the interconnection of the upper layer network.
Answer: A
NEW QUESTION 31
Which of the following statements about copper wire access are wrong? (Multiple choice)
- A. Twisted Pair is a signal transmission cable made of two or more pure copper wires insulated from each other.
- B. The corridor distribution box belongs to the copper distribution network.
- C. The copper wire access consists of three parts: the central office access device, the copper wire distribution network and the user access terminal.
- D. The equipment room distribution frame does not belong to the copper distribution network.
Answer: A,D
NEW QUESTION 32
Which chassis can be installed on the N63E-22? (Multiple Choice)
- A. MA5800-X17 ETSI chassis
- B. MA5683T chassis
- C. MA5608T chassis
- D. MA5800-X2 chassis
Answer: A,B,C,D
NEW QUESTION 33
What are the reasons for the behavior of EHS accidents and EHS incidents? (Multiple choice)
- A. Take safety as a play
- B. No reminders to be safe
- C. Use of dangerous facilities or damaged facilities
- D. Unauthorized work
Answer: A,B,C,D
NEW QUESTION 34
The location of the supplier communication equipment connected to the power supply output breaker of the equipment room should be determined according to which of the following options? (Multiple Choice)
- A. Reserved terminals for customer planning
- B. Design documents
- C. Free use of idle terminals
- D. Connected on the large rated output terminal
Answer: A,B
NEW QUESTION 35
Which of the following statements are the correct description of the PDU? (Multiple choice)
- A. The input cable of the single-phase AC PDU is a five-core industrial plug
- B. The input cable of the three-phase AC PDU is a five-core industrial plug.
- C. The input voltage and output voltage of the single-phase AC PDU are both 220V.
- D. The input voltage and output voltage of the three-phase AC PDU are both 380V.
Answer: B,C
NEW QUESTION 36
What is the height of the 3.5-inch disk enclosure?
- A. 6U
- B. 4U
- C. 2U
- D. 1U
Answer: B
NEW QUESTION 37
Which is the correct statement about MSO? (Multiple choice)
- A. Domestic radio and television and Digital belong to MSO business
- B. MSO refers to Multiservice Operator, which refers to operators that provide services such as TV and broadband through coaxial cable (TV line).
- C. Twisted pair is the MSO household resource
Answer: A,B
NEW QUESTION 38
Regarding the MA5800 frame type equipment, the equipment installation environment quality standards, what are the correct statements? (Multiple Choice)
- A. AC power supply related parameters are in line with the long-term safe operation of the equipment. The equipment room AC power system should have a lightning protection unit, and the lightning protection unit should be grounded reliably.
- B. Customer's PGND cable, GND cable of primary power supply, wire diameter and power supply mode of a 48V cable to PDF or distribution box, subject to engineering design documents and company shipments, to meet equipment operation and capacity expansion requirements.
- C. The AC protection ground of the AC power supply should be reliably connected to the AC protection ground. The GND grounding and PGND grounding provided by the customer must be connected to the same grounding body.
- D. No fire and anti-static measures are required in the equipment room.
Answer: A,B,C
NEW QUESTION 39
In the process of powering up the server, which indicator status indicates that the server is in the Standby state?
- A. Off
- B. Yellow long bright
- C. Green long bright
- D. Yellow flashing
Answer: B
NEW QUESTION 40
When driving, what kind of phone call does we absolutely forbid the driver to use?
- A. Handheld phone
- B. Speakerphone
Answer: A
NEW QUESTION 41
What is the purpose of keeping the work site tidy?
- A. Just to meet the requirements of the EHS specification
- B. Prevent nails and other protrusions from injuring workers or tripping them
- C. Make your work comfortable
Answer: B
NEW QUESTION 42
......
Prepare Top Huawei H35-912 Exam Audio Study Guide Practice Questions Edition: https://www.testvalid.com/H35-912-exam-collection.html